Page 1 of 1

Carb heater fitting

Posted: Mon May 14, 2018 8:49 am
by namtabmai
Without going into details of what ham fisted ape did what, I've found myself with a carb heater fitting which has one of the plastic arms broken.

I've read that people have removed these but I'd like to at least have a stab at getting them working again before going that route.

Am I right in thinking this is part 92005B-1291? Because it looks like like SOL unless I want to spend £40 getting one from America.

Think I could get away with using epoxy to repair it?

Re: Carb heater fitting

Posted: Mon May 14, 2018 2:29 pm
by banner001
If it's the angled bit that physically goes into the carb, then yes, that will come with new o rings as well