Page 1 of 1
valve clearances
Posted: Wed Feb 24, 2016 5:07 pm
by richyrd5
Where do you check between...400h..lobe and rocker or shim and rocker.??my nc30 is the same as near as in valve train and that is shim and rocker(even though Haynes book of lies says lobe and rocker!)..thanks
Re: valve clearances
Posted: Wed Feb 24, 2016 5:14 pm
by Dominik
Between lobe and rocker is right if you go for 13-17/16-21 clearance.
In the kit manual there are bigger clearances mentioned which should get measured between shim and rocker
Re: valve clearances
Posted: Wed Feb 24, 2016 5:28 pm
by richyrd5
excellent.thanks dom