Clutch not fully disengaging

Moderator: Moderators

Post Reply
JamieNeve
Posts: 197
Joined: Fri Jan 25, 2013 12:33 pm
My Bike: CBR600RR, ZXR400 L-2
Location: Waterlooville, Hampshire

Clutch not fully disengaging

Post by JamieNeve »

Basically when I pull my clutch lever in fully, there is still quite alot of resistance from the gears. I have tried tightening the cable at both ends (actuator rod and lever) however this just makes the clutch stiffer but not disengage properly.

Is this a symptom of new plates required or a new basket or the whole thing?

Cheers guys.
Post Reply