depth of shock linkage bearings
Posted: Fri Mar 28, 2014 12:30 pm
Hey guys long time, hope everyone is well.
Having finally got round to powder coating a few bits and pieces I have come to put new bearings back in.
However I notice that the shock linkage bearings could be pressed all the way in till they touch or just enough to get the caps\seals on. I'm thinking they should just go in as to allow room for where a grease nipple would have feed from. (My linkage does not have nipples)
If anyone could shed some light on this that would be great
Thanks
Having finally got round to powder coating a few bits and pieces I have come to put new bearings back in.
However I notice that the shock linkage bearings could be pressed all the way in till they touch or just enough to get the caps\seals on. I'm thinking they should just go in as to allow room for where a grease nipple would have feed from. (My linkage does not have nipples)
If anyone could shed some light on this that would be great
Thanks