There are 2 nuts and bolts holding the ignition switch in, 1 set has fallen out of mine...
does anyone know what size they are??
Thanks!
Nut and bolt holding the ignition in?
Moderator: Moderators
-
- Posts: 40
- Joined: Sat Apr 21, 2007 6:51 pm
- My Bike: 98' ZXR400
- Location: Manchester
Nut and bolt holding the ignition in?
Thanks!
Oli
Oli
-
- Posts: 88
- Joined: Thu Jul 19, 2007 4:20 pm
- My Bike: zxr400
- Location: manchester
Re: Nut and bolt holding the ignition in?
I imagine the other 1 would be the same size so take it to a bike shop and ask if they can get that.
ride with pride
- masterofinsanity
- Site Admin
- Posts: 8103
- Joined: Thu Aug 29, 2002 12:36 am
- My Bike: Aprilia Tuono Fighter
- Location: England
- Contact:
Re: Nut and bolt holding the ignition in?
they should be speacial snap off bolts, if they have been replaced then someone must have put cap heads in them, then take the other out and let me know what size it is, i'll drop you one in the post.
Don't forget people there is more to the zxr400 than this forum... check out www.zxrworld.co.uk also.
-
- Posts: 40
- Joined: Sat Apr 21, 2007 6:51 pm
- My Bike: 98' ZXR400
- Location: Manchester
Re: Nut and bolt holding the ignition in?
right, thanks. Ill have a go at taking it off, to be fair I did have an attempt but it is a bitch to get to, like my hand doesnt really fit in to that gap. Ill have another go I suppose.
Thanks!
Oli
Oli
-
- Posts: 40
- Joined: Sat Apr 21, 2007 6:51 pm
- My Bike: 98' ZXR400
- Location: Manchester
Re: Nut and bolt holding the ignition in?
right, Ive found out what it is. Its a torx M6,, you need a female torx (which I couldnt find) to put it in, and the end snaps off once its tight enough. Well put an M6 caphead instead... seems to do the job. So if the bolt falls out thats holding the ignition barrel in.. its an M6...
Thanks!
Oli
Oli
- masterofinsanity
- Site Admin
- Posts: 8103
- Joined: Thu Aug 29, 2002 12:36 am
- My Bike: Aprilia Tuono Fighter
- Location: England
- Contact:
Re: Nut and bolt holding the ignition in?
did you happen to measure it before you put it in?
Don't forget people there is more to the zxr400 than this forum... check out www.zxrworld.co.uk also.
-
- Posts: 40
- Joined: Sat Apr 21, 2007 6:51 pm
- My Bike: 98' ZXR400
- Location: Manchester
Re: Nut and bolt holding the ignition in?
Well, I went and bought the part from my local kawa place £1.20 for a fkin bolt, but didnt have the tool to put it in, so I went to the techinicians area whilst I was in uni, and looked in to their stores, compared the thread to an M6 and was prefect match,even tried on an M6 nut on the bolt I bought and was right, so I just shortened the caphead and tightened it in.
Thanks!
Oli
Oli