Anyone have SP tail Unit???

Post by **Miles** » Thu Jul 22, 2010 6:44 pm

Hey folks trying to track down a kwak SP tail unit, always thought they looked better than any other ones. Been waiting on ebay for quite awhile but to no luck.

Anyone have one there looking rid of? any colour or condition

RedexRobB · Post by **RedexRobB** » Thu Jul 22, 2010 8:37 pm

Ive got one but its not for sale unfortunately. They are quite hard to come by, i bought mine then didnt see another for months then two came along at once both less than 100 quid, wish id bought them now.

Good luck with the search they are out there!

Post by **zimm** » Fri Jul 23, 2010 5:05 pm

I've got one .. mint condition, genuine SP G/W/B M1 colours, but like rob, Im keeping it

real ones are uber rare in good nick

BB plastics do an SP shape seat for about Â£80 though, and their stuff is good quality

http://www.bbplastics.co.uk/Shop/Fairin ... g-Kit.html

(bottom left, the other one is like the normal seat unit, but single)

Post by **Miles** » Fri Jul 23, 2010 5:29 pm

They look pretty good but do you know if the non 'race' one (on the right) will accomindate the fuel tap?

Post by **zimm** » Fri Jul 23, 2010 6:04 pm

Miles wrote:They look pretty good but do you know if the non 'race' one (on the right) will accomindate the fuel tap?

should do .. its for road bikes.. and has the cutout for one .. exactly the same as the standard panels, only without the pillion pad, and in one piece.

best to contact them with your specific requirements.

skullie · Post by **skullie** » Sat Feb 11, 2012 2:30 pm

will one of these fit a zx400g
the rear section of my bike is totalled both lugs have broke off and missing

ZX4R-F3 · Post by **ZX4R-F3** » Sun Feb 12, 2012 12:02 am

Re: Anyone have SP tail Unit???
by skullie Â» Sat Feb 11, 2012 2:30 pm

will one of these fit a zx400g
the rear section of my bike is totalled both lugs have broke off and missing

Not unless you have an angle grinder handy.

Andy

BinsAreForBombs · Post by **BinsAreForBombs** » Fri Apr 12, 2013 7:24 pm

Anyone know where/how I can get the standard shaped one (to fit the original seat/fuel tap etc) with a cut out for the rear light?? If not, how much of a bugger would cutting the hole for light be? Anyone done it?

Cheers!

RedexRobB · Post by **RedexRobB** » Sat Apr 13, 2013 8:19 am

I had to cut them out on my first ZXR with a jigsaw cutter. Its hassle and the gel coat chipped quite easily, so if you can source one already cut then i would say go that route. Im pretty sure the pre-cut units are available.