Page 1 of 1
Change end can ?
Posted: Sun Jun 09, 2013 3:07 pm
by JulianWerner
Hi guys.
I have the standard downpipes, and end can.
I want to get some more noise from this bike, does the PipewerX end can fit original pipes ?
If not, does anyone know about slip on cans for the original pipes ?
Re: Change end can ?
Posted: Sun Jun 09, 2013 11:08 pm
by CaNsA
The original pipes aren't slip on.
Re: Change end can ?
Posted: Tue Jun 11, 2013 12:00 am
by JulianWerner
Is one of these recommended then ?
http://viewitem.eim.ebay.no/Kawasaki-ZX ... 90498/item
http://viewitem.eim.ebay.no/ZXR400-ZXR- ... 16965/item
Maybe this one ?
http://viewitem.eim.ebay.no/Kawasaki-ZX ... 13650/item
EDIT:
I read a little bit about it, and it seems to me that " Micron " system is the best downpipes ?
Do you know where i could get one ?
Thanks so much for replying
Re: Change end can ?
Posted: Tue Jun 11, 2013 11:03 am
by banner001
your second link (
http://viewitem.eim.ebay.no/ZXR400-ZXR- ... 16965/item) will allow you to use 3-bolt bolt-on cans, or 52mm slipons, the delkavic exhausts are replicas of the originals and wont allow you to use anything other than a 3-bolt exhaust (with the same bolt-spacing as the original can).
micron are a ~60+mm outlet and are generally seen as a "race" exhaust, if you can get one, congratulations, they are getting rarer
Re: Change end can ?
Posted: Tue Jun 11, 2013 1:56 pm
by JulianWerner
I think i will go for the SandySpare pipes.
Do some of you guys know if PipewerX cans will fit these pipes?
If not maybe another silencer ?
Re: Change end can ?
Posted: Tue Jun 11, 2013 2:45 pm
by banner001
best bet is email pipewerx, i think its a 3-bolt fitting, but if not, just ask them what diameter slip-on it will fit.
Re: Change end can ?
Posted: Mon Jun 24, 2013 12:22 pm
by ross46
yeah the pipewerx can do fit the original downpipes, i had a chat with one of the guys at nec