Bike won't go over 90mph
Moderator: Moderators
-
- Posts: 7
- Joined: Tue Aug 04, 2009 10:01 pm
- My Bike: zxr l9 400cc
- Location: hull
Bike won't go over 90mph
Been out on bike to day and when got to 90 it just didn't want t go any faster throttle was fully open . Plus the bike don't seem quick enough for a 400 . Any ideas ppm? Cheers
- CaNsA
- zxr400 oc member
- Posts: 1741
- Joined: Sat Nov 29, 2008 4:02 pm
- My Bike: ZX6R F1
- Location: Liverpool
Re: Bike won't go over 90mph
fuel > Air mixture is well off. mine done the same until i covered up 1/3 of the snorkel
Moderator & Skilled Ban Hammer Operator!
Has this forum helped you out? Say thanks by donating some of your hard earned cash towards running costs.
:: <=-LOADED TELLY BOXES - NO CONTRACT - NO SUBSCRIPTION - PM ME-=> ::
Has this forum helped you out? Say thanks by donating some of your hard earned cash towards running costs.
:: <=-LOADED TELLY BOXES - NO CONTRACT - NO SUBSCRIPTION - PM ME-=> ::
-
- Posts: 7
- Joined: Tue Aug 04, 2009 10:01 pm
- My Bike: zxr l9 400cc
- Location: hull
Re: Bike won't go over 90mph
So I'm gathering that's on the carbs. Another thing it does is when stop at lights revs stay pretty high for a few mins then calm down around 3k does this when warm
-
- Posts: 7
- Joined: Tue Aug 04, 2009 10:01 pm
- My Bike: zxr l9 400cc
- Location: hull
Re: Bike won't go over 90mph
I have put this post on here as I didn't know if the bike was restricted or not !
- RedexRobB
- Site Admin
- Posts: 7212
- Joined: Fri Aug 30, 2002 7:37 pm
- My Bike: ZXR400L3
- Location: Ipswich, Suffolk
Re: Bike won't go over 90mph
it doesnt sound like its restricted, sound like you have an air leak going by the hanging revs when you pull up to a stop. The inlet rubbers are usually the cause for that, a bit of sealant between the inlet and the engine block usually cures it, or if you really fussy new o'rings. Might also want to check the carb clamps are done up tightly too, no going any faster than 90 suggests its more than a small air leak. Also check the airbox is sitting flush on top of the carbs.
-
- L-plate hell
- Posts: 279
- Joined: Sat Sep 06, 2008 10:54 pm
Re: Bike won't go over 90mph
The hanging revs do suggest an air leak, but i wouldn't have thought that would account for it not going over 90.... This does sound like it could be a 33hp restriction, although even then they tend to be able to go more than 90. With a strong tail wind my old vfr would just about do 90 restricted AND running on 3 cyclinders.
Check all ure downpipes are getting hot to make sure it is running 4...
Check all ure downpipes are getting hot to make sure it is running 4...
- extonyg
- zxr400 oc member
- Posts: 405
- Joined: Tue May 12, 2009 9:40 pm
- My Bike: zxr 400 L1 uk
- Location: Portsmouth
Re: Bike won't go over 90mph
sounds like to me it is restricted.........does it rev out fully in the lower gears?? as the restrictor plates can also cause air leaks causing the hanging revs and lower top end.
- Mad Phil
- Posts: 91
- Joined: Wed Jun 24, 2009 6:39 pm
- My Bike: Hayabusa, Ducati 996SPS
- Location: Stoney Stanton, Leicestershire
Re: Bike won't go over 90mph
Whats it rev to off load 10k or 12.5K ?
-
- Posts: 7
- Joined: Tue Aug 04, 2009 10:01 pm
- My Bike: zxr l9 400cc
- Location: hull
Re: Bike won't go over 90mph
It revs to around 12 . Checked the Cdi unit and it's blue with an m on so won't be that. And it's a uk bike. It seems to struggle after 70. Really jerky. Will have to try some were on Monday to have a look at the carbs . 1&2 nd all seem good and no limitnon that.
-
- L-plate hell
- Posts: 479
- Joined: Sun Oct 12, 2008 11:12 am
- My Bike: ZXR400 L4, ZX6R F1 track
- Location: Chesterfield
Re: Bike won't go over 90mph
agree with cansa. Sounds like it needs a Dynojet kit or similar. Does full throttle work at all?
- Mad Phil
- Posts: 91
- Joined: Wed Jun 24, 2009 6:39 pm
- My Bike: Hayabusa, Ducati 996SPS
- Location: Stoney Stanton, Leicestershire
Re: Bike won't go over 90mph
How long have you had the bike & has it always been like it ?
- extonyg
- zxr400 oc member
- Posts: 405
- Joined: Tue May 12, 2009 9:40 pm
- My Bike: zxr 400 L1 uk
- Location: Portsmouth
Re: Bike won't go over 90mph
has it got uk carbs on it?they havent been replaced for 30mm ones have they??
mine is a uk spec bike and revs to 14k......
start with all the basics though.......check fuel pump, air leaks, spark plugs etc
mine is a uk spec bike and revs to 14k......
start with all the basics though.......check fuel pump, air leaks, spark plugs etc