Bike won't rev past 9 half rpm

[Mori Man]

Sorry to say I don't have an H loom handy - it's at the back n beyond of my store room or I could have laid it out and shown you.

For some reason the manual doesn't show the Pink wire but I guess it would then make it too easy to come up with a bypass for it.

I am sure there is a thread somewhere telling you what size of resistor to connect to what pin of the CDI to fool the speed circuit.

MM!

[Dolts]

Just read through this topic, and its got me wondering, i am building a track bike and have had my loom converted to a race loom my track electronics i think it was, it is connected to a uk CDI, will it be in failsafe mode as i have no speedo?

[Mori Man]

Your all right Dolts , UK CDI has no speed restriction circuit in it.

[technicalmoto]

Developments

There is a pink wire on the CDI. I get the resistor to ground mod, this will take place this week and will report back.

The number on the CDI is not one I have seen on the forum. Red label, 21119-1271, 131800-5240, 12v TNCF07 A is a Denso unit. Any info on this fella's?

[Mori Man]

The number on the CDI is not one I have seen on the forum. Red label, 21119-1271, 131800-5240, 12v TNCF07 A is a Denso unit. Any info on this fella's?

H1 / J1 CDI

[technicalmoto]

Thanks

I did a little more digging and as you confirm its a Japan spec cdi with the speed limiter. I will fit resistor to overcome this.

Gotta say this forum is a fantastic resource for the ZXR.......

I did look at programmable CDI's for £165 but the resistor is deffo cheaper.