zxr 400 restrictor washer dimensions

[lindaloo]

Image0002.JPG

Hope this is ok for everyone?

[masterofinsanity]

yeah just need to turn my monitor on its side

this is what they should look like when you've made you're own

[lindaloo]

save pic and print???

[Carl Howell]

Sorry to bring this topic back up but could you please tell me the thickness of the washers and the material used.

Thanks, Carl

[rover220]

thckness doesnt matter really, any material will do. id make some out od sheet steel.

[Carl Howell]

Is that a picture of the washer drawn round? If so then I can print it off and build them to scale if you know what I mean.

[masterofinsanity]

its copyrighted mate

[Carl Howell]

Lol. If I get some made does anyone want a free set of 4 to tell me if they work as I don't have a ZXR (yet) to try them on.

[masterofinsanity]

i'll borrow a set to do a feature on how to fit em.

[Vard66]

That sounds like just the ticket, M.o.I.

[Carl Howell]

I will see if I can find somewhere to make some then. Can't promise anything though

[zimm]

[masterofinsanity]

surely all you need to do is draw around your carb rubbers and drill a 15.4mm (i always understood they were 16mm) hole in the centre??

[rover220]

surely all you need to do is draw around your carb rubbers and drill a 15.4mm (i always understood they were 16mm) hole in the centre??

yes, it really is as simple as that!

[zimm]

yeh, I was just playing round with a new graphics app, and this seemed as good a use as any.