www.zxrworld.co.uk

Hi i have seen the measurements for the washers i was wondering if you could help me with some other queries such as:

Where side of the carb do they go?
What thickness does the washer have to be?
What material just standard steel, aluminium??


Thanks

Tom

I think they bolt on useing the same screws that hold the carb rubbers on.....

Thickness ? what have you got siting in the scrap bucket....................... 2mm perhaps

Don't think material matters

Ally for lightness
Steel for rust
Stainless for blunt drill bits trying to make them

Thanks

has anyone actually made their own for there zxr?

personaly i didnt bother the bike can be restricted ANY way you want so pull 3 HT leads off and its restricted..