www.zxrworld.co.uk

Hi all , i recently purchased a shiny new torque wrench and started checking my bike top to bottom got to my crash bungs and was wondering what the setting for these should be the manual says for standard 44nm is this correct with the bungs fitted? thx

Yeah do them as tight as it says in the manual.

what i do, is after they are tightened up to whatever, make a little mark with tipex where you can see on the bolt head. that way you can have a little glance to see if the bolt have moved and needs tightening up again. I much prefare this than using the devils goo locktite on any of my bolts.
having said that, you might not want white tipex all over yr bike!

Cheers everyone did it to 44nm seems k they were well to tight before ooops