So yeah, that micron zorst arrived. Mint condition down pipes dont look bent.
looking at the front of the bike and starting from the left,
#1 #2 and #3 fit nicely into the collector but #4 is being an absolute pikey and wont sit flush causing the end can to be out of line with the hanger.
Am i going to need a rubber mallet?
Bloody Zorst!
Moderator: Moderators
- CaNsA
- zxr400 oc member
- Posts: 1741
- Joined: Sat Nov 29, 2008 4:02 pm
- My Bike: ZX6R F1
- Location: Liverpool
Bloody Zorst!
Moderator & Skilled Ban Hammer Operator!
Has this forum helped you out? Say thanks by donating some of your hard earned cash towards running costs.
:: <=-LOADED TELLY BOXES - NO CONTRACT - NO SUBSCRIPTION - PM ME-=> ::
Has this forum helped you out? Say thanks by donating some of your hard earned cash towards running costs.
:: <=-LOADED TELLY BOXES - NO CONTRACT - NO SUBSCRIPTION - PM ME-=> ::
-
- Posts: 19
- Joined: Mon May 09, 2011 6:06 pm
- My Bike: Honda RVF400
- Location: Bury, Suffolk
Re: Bloody Zorst!
I had a friend help with mine and we managed to pull the outer two pipes out and slot them in, then a little bit of pushing on them as we bolted and they're all in fine. Getting the old ones out was the hardest part I found!
-
- Posts: 19
- Joined: Mon May 09, 2011 6:06 pm
- My Bike: Honda RVF400
- Location: Bury, Suffolk
Re: Bloody Zorst!
Also not sure how your system is, but I fitted the downpipes alone then the slip on after they were in place.