Anyone know why my clutch slips under really hard acceleration? The bike hadnt been used for a few years before I had it, and the clutch fluid was black, so i changed that.
Going to do a gerabox oil change, but if the clutch is dead then might as well replace that at the same time.
And anyone know how much a clutch puller thing that holds it stead while you undo the main bolt costs?
Thank you people!
Dyl
Slipping clutch ZX7R
Moderator: Moderators
- Dylan
- Posts: 64
- Joined: Mon Jun 30, 2003 8:08 pm
- My Bike: tomos moped
- Location: Bury St Eds, Suffolk, or Leeds
- Contact:
- masterofinsanity
- Site Admin
- Posts: 8103
- Joined: Thu Aug 29, 2002 12:36 am
- My Bike: Aprilia Tuono Fighter
- Location: England
- Contact:
probably down to the oil your using mate?
Don't forget people there is more to the zxr400 than this forum... check out www.zxrworld.co.uk also.
- Dylan
- Posts: 64
- Joined: Mon Jun 30, 2003 8:08 pm
- My Bike: tomos moped
- Location: Bury St Eds, Suffolk, or Leeds
- Contact:
- SimonH
- Posts: 57
- Joined: Thu Aug 29, 2002 11:39 am
- My Bike: tomos moped
- Location: sunny Bournemouth
- Contact:
- Dylan
- Posts: 64
- Joined: Mon Jun 30, 2003 8:08 pm
- My Bike: tomos moped
- Location: Bury St Eds, Suffolk, or Leeds
- Contact:
- SimonH
- Posts: 57
- Joined: Thu Aug 29, 2002 11:39 am
- My Bike: tomos moped
- Location: sunny Bournemouth
- Contact:
http://homepage.ntlworld.com/webzxr/zxr ... lutch.html
just a case of changing the plates to thinner ones as far as I can see....will give it a go when I drop my engine next week.....not much use for a slipper clutch on the road though but, hell its cool!
just a case of changing the plates to thinner ones as far as I can see....will give it a go when I drop my engine next week.....not much use for a slipper clutch on the road though but, hell its cool!
SIR (used to) CRASHALOT
- Dylan
- Posts: 64
- Joined: Mon Jun 30, 2003 8:08 pm
- My Bike: tomos moped
- Location: Bury St Eds, Suffolk, or Leeds
- Contact: