www.zxrworld.co.uk

hi guys

whats needed to do the job properly?

ive ordered so far, the hg, base and exhaust gaskets.

anything else needed on top of this?

cheers

new camchain? been a while since i've done this but dont you have to split the camchain to get the heag off?

If the chain gets stuck at the bottom you can always file away the bit of casing to get it through, its a mod thats been done before.

no the camchain wont need splitting

so i dont need any other parts then other than what ive listed?

a head gasket, you havent listed that

Can you re-use the head bolts? Or are they re-usable?

RobB wrote:a head gasket, you havent listed that

Can you re-use the head bolts? Or are they re-usable?

im assuming you can reuse them, doesnt mention anything about them in the manual.

and yes, i have listed headgasket.

you have havent you, why i took hg as something to do with a compression tester i dont know, isnt hg something to do with measuring the hydrogen content in something like battery fluid?

RobB wrote:you have havent you, why i took hg as something to do with a compression tester i dont know, isnt hg something to do with measuring the hydrogen content in something like battery fluid?

im not sure lol, "in/hg" is a measurement of pressure if that means anything.

ive been lookng at the manual and to replace the base gasket, it looks like im gonna have to remove pistons/rings and refit... is this correct?

Yeah defo need to do that, no other way to get the base gasket on because the locating studs for the block pass through it.

i read hg as head gasket