Rob the cr9 eix iridium plugs are single contact well i hope they are as that's what i put in mine after asking bloke on ngk stand.Please please please dont tell me i put wrong ones in
There are only three kinds of people; people who can count and people who can't.
2) Are the carbs set up for carb heating (inlet and outlet and joining hoses across the base
3) You need the hose attachement shown in pic three - this is the UK spec and has a take off in the middle for the small flex taking the coolant back from the carbs
Not sure what the inline devices are on the supply and return hoses for the collant to the acrbs but I assume some sort of NRV to prevent crossfolw from fuel to coolant (or vice versa) - or some sort of folw regulator
You do not have the required permissions to view the files attached to this post.
engine block thing yes got a screw in it atm that looks liek its been silaconed in :S
umm carb heater pipes ill have to checuk tomorrow as ill have to take the carbs of . thing is if my carbs aint got them dont wanna change carbs just had them cleaned and balanced
The burbling and cutting out could also be condensation from the cold weather. I've just this minute finshed putting my bike back together after a routeen check. Found that my breather pipe has drops of water in it, airbox swimming in water, and 2 HT caps a tad loose.
Regards
Rich
MillaMeter's ZXR400 Restoration Click HERE!
ZXR400s 4eva! I miss mine already