my bike needs full throttle to starts. I've already tried some mixture screw settings, but with no results. Any suggestions?
full throttle startings
Moderator: Moderators
-
FraZX4R
- Posts: 5
- Joined: Mon Jul 06, 2009 8:31 am
- My Bike: zxr 400
full throttle startings
hi everyone,
my bike needs full throttle to starts. I've already tried some mixture screw settings, but with no results. Any suggestions?
my bike needs full throttle to starts. I've already tried some mixture screw settings, but with no results. Any suggestions?
-
CaNsA
- zxr400 oc member
- Posts: 1742
- Joined: Sat Nov 29, 2008 4:02 pm
- My Bike: ZX6R F1
- Location: Liverpool
Re: full throttle startings
Tried adjusting the idle?
-
zimm
- zxr400 oc member
- Posts: 2320
- Joined: Tue Oct 10, 2006 12:32 am
- My Bike: ZXR400-M4, ZX4, ZX6R.
- Location: Herefordshire
Re: full throttle startings
check/set the valve clearances
-
FraZX4R
- Posts: 5
- Joined: Mon Jul 06, 2009 8:31 am
- My Bike: zxr 400
Re: full throttle startings
the idle is around 1400 rpm, so it should be ok
and i'm not able (and really don't have the time
) to check the valve clearances, especially if I'm not sure about the problem
Has anyone had the same problem?
P.S. i was wondering, in order to clean the jets, can i remove the float bowl without taking off the carbs?
thank you guys (and don't look at the writing mistakes please
)
and i'm not able (and really don't have the time
) to check the valve clearances, especially if I'm not sure about the problemHas anyone had the same problem?
P.S. i was wondering, in order to clean the jets, can i remove the float bowl without taking off the carbs?
thank you guys (and don't look at the writing mistakes please
)