John Harris Honda (Crowborough) :S
Moderator: Moderators
- zxr_oli
- zxr400 oc member
- Posts: 319
- Joined: Sat Jun 02, 2007 10:42 am
- My Bike: Daytona 675
- Location: East Sussex
John Harris Honda (Crowborough) :S
well, they just failed my RS on an mot, which is fair enough.
but i got there to find my bike leaning against the wall, so i immediately have a look at the side stand to see if there is a problem only to find when the side stand is used it bends right out.
when confronted about this they deny all knowledge of this, and eventually agree to repair it after arguing with them.
he also says that it wouldnt start, so i simply state that i have never had starting problems and that it started fine when i took it to them, then they start accusing me of calling them liars.
through out this it felt as if they were talking down to us because i am 17 on l plates and i had my mum with me.
so know i'm waiting for them to repair it, which they say will take ~45min to weld one small bit of metal.
if anyone in this area is thinking about using them, think again.
ok, my rant over :smt013
but i got there to find my bike leaning against the wall, so i immediately have a look at the side stand to see if there is a problem only to find when the side stand is used it bends right out.
when confronted about this they deny all knowledge of this, and eventually agree to repair it after arguing with them.
he also says that it wouldnt start, so i simply state that i have never had starting problems and that it started fine when i took it to them, then they start accusing me of calling them liars.
through out this it felt as if they were talking down to us because i am 17 on l plates and i had my mum with me.
so know i'm waiting for them to repair it, which they say will take ~45min to weld one small bit of metal.
if anyone in this area is thinking about using them, think again.
ok, my rant over :smt013
-
- L-plate hell
- Posts: 253
- Joined: Mon Jan 01, 2007 10:07 pm
Re: John Harris Honda (Crowborough) :S
hi, dont worry about it, you and learn ive been in them situations, last one 6 months ago or so, the dealers just end up ripping you off, and not to mention the 200 quid service cost, dont worry matey take it as a learning curve get your bike back as soon as possible and just simple dont go back there,
Rob
Rob
-
- zxr400 oc member
- Posts: 1918
- Joined: Fri Feb 23, 2007 10:34 am
- My Bike: kwack ZXR750L1
- Location: Northampton
Re: John Harris Honda (Crowborough) :S
would have done it while inspecting the wheel bearins ect they lift the bike up onto the side stand so the wheel is in the air, while at it they prob killed the side stand switch so might be why its not starting
ZXR750 L1
tail tidy, polished bits, custom paint job, k&n, dynojet, Full akropovik, down geared, GSXR calipers, hel brake lines front and rear & clutch line, maxtron resprung froks 120BHP
BikePics page-
http://www.bikepics.com/members/zxr400rene/
tail tidy, polished bits, custom paint job, k&n, dynojet, Full akropovik, down geared, GSXR calipers, hel brake lines front and rear & clutch line, maxtron resprung froks 120BHP
BikePics page-
http://www.bikepics.com/members/zxr400rene/
- RedexRobB
- Site Admin
- Posts: 7212
- Joined: Fri Aug 30, 2002 7:37 pm
- My Bike: ZXR400L3
- Location: Ipswich, Suffolk
Re: John Harris Honda (Crowborough) :S
If thats the condition they gave it back to you i sure wouldnt let them fix it! I would either do it my self or take it to somewhere i trust and as mentioned, wouldnt go back.
-
- zxr400 oc member
- Posts: 584
- Joined: Tue Feb 06, 2007 7:48 pm
- My Bike: Unique ZXR400
- Location: Little Sutton Cheshire
Re: John Harris Honda (Crowborough) :S
unlucky Oli. And you thought it was hassle to get them to MOT it, now its a pain in the butt.
Andy


- Gemini
- cloning technology
- Posts: 1323
- Joined: Fri Nov 15, 2002 1:57 pm
- My Bike: CBR1000RR4 Fireblade
- Location: Shrewley, Warwickshire
Re: John Harris Honda (Crowborough) :S
im sure u can report mot tsters to the dvla?
maybe im wrong
but as i understand it the dvla and trading standards are clampin down on cowboys like the mentioned
gem
maybe im wrong
but as i understand it the dvla and trading standards are clampin down on cowboys like the mentioned
gem
There's No Explanation For The Way I'm About To Behave!!!
-
- Full Licence rider
- Posts: 1372
- Joined: Fri Feb 16, 2007 10:36 am
- Location: Wolverhampton
Re: John Harris Honda (Crowborough) :S
Yea im quite sure that you can report them to trading standards but i think you might have to proove it. maybe one of the guys employees bost it but said nothing through fear of loosing his job anythings possible aint it.
oh an its always worth noting your milage before an MOT an all you dont wana find a couple of hundred more miles on the clock haha
oh an its always worth noting your milage before an MOT an all you dont wana find a couple of hundred more miles on the clock haha
Remember speed kills, so does smoking, drinking, drugs, fast food and many more good things
-
- zxr400 oc member
- Posts: 1918
- Joined: Fri Feb 23, 2007 10:34 am
- My Bike: kwack ZXR750L1
- Location: Northampton
Re: John Harris Honda (Crowborough) :S
that happened to me, took my corsser for a MOT and it came back with a extra 40 miles on the clock. I know they took it some were else to get the MOT done as its a new company but still its only 20 miles max there and back
ZXR750 L1
tail tidy, polished bits, custom paint job, k&n, dynojet, Full akropovik, down geared, GSXR calipers, hel brake lines front and rear & clutch line, maxtron resprung froks 120BHP
BikePics page-
http://www.bikepics.com/members/zxr400rene/
tail tidy, polished bits, custom paint job, k&n, dynojet, Full akropovik, down geared, GSXR calipers, hel brake lines front and rear & clutch line, maxtron resprung froks 120BHP
BikePics page-
http://www.bikepics.com/members/zxr400rene/
- zxr_oli
- zxr400 oc member
- Posts: 319
- Joined: Sat Jun 02, 2007 10:42 am
- My Bike: Daytona 675
- Location: East Sussex
Re: John Harris Honda (Crowborough) :S
i dont think they did anything dodgy MOT wise, only broke the back of the stand and ran the battery flat, started fine bumb starting, rode it round the block to charge it up a bit and it was fine
anyone know what angle the head light it ment to be?

anyone know what angle the head light it ment to be?
-
- Full Licence rider
- Posts: 1372
- Joined: Fri Feb 16, 2007 10:36 am
- Location: Wolverhampton
Re: John Harris Honda (Crowborough) :S
Good god 40 miles on the clock that would annoy me to think that someone has been blastin my bike around without my consent. did you say anythin to em?
Remember speed kills, so does smoking, drinking, drugs, fast food and many more good things
-
- zxr400 oc member
- Posts: 1918
- Joined: Fri Feb 23, 2007 10:34 am
- My Bike: kwack ZXR750L1
- Location: Northampton
Re: John Harris Honda (Crowborough) :S
nah wasnt that bothered i know the poeple there and they also sorted out the fueling problem that id noticed the day before so its not a bad deal!
ZXR750 L1
tail tidy, polished bits, custom paint job, k&n, dynojet, Full akropovik, down geared, GSXR calipers, hel brake lines front and rear & clutch line, maxtron resprung froks 120BHP
BikePics page-
http://www.bikepics.com/members/zxr400rene/
tail tidy, polished bits, custom paint job, k&n, dynojet, Full akropovik, down geared, GSXR calipers, hel brake lines front and rear & clutch line, maxtron resprung froks 120BHP
BikePics page-
http://www.bikepics.com/members/zxr400rene/
-
- Full Licence rider
- Posts: 1372
- Joined: Fri Feb 16, 2007 10:36 am
- Location: Wolverhampton
Re: John Harris Honda (Crowborough) :S
i suppose its different if you already know em an that.
Remember speed kills, so does smoking, drinking, drugs, fast food and many more good things
-
- L-plate hell
- Posts: 488
- Joined: Fri Mar 07, 2003 5:35 pm
- My Bike: GSX-R600 K4
- Location: Oxfordshire
- Contact:
Re: John Harris Honda (Crowborough) :S
you can report dodgy test centres.
I always hang around for my MOT - if they wont do it whilst I wait, I take it else where. I also always take it with an *almost* empty tank of fuel for the exact reason about people riding it around - on another note, I took my car to MOT once whilst it was on reserve - it came back with more fuel in it than it went
head light angle - so it doesnt blind people and lights up a reasonable amount of the road - wait until it is dark and shine your headlights up against a garage wall or somthing, should be easy enough to see if they are too high.
I always hang around for my MOT - if they wont do it whilst I wait, I take it else where. I also always take it with an *almost* empty tank of fuel for the exact reason about people riding it around - on another note, I took my car to MOT once whilst it was on reserve - it came back with more fuel in it than it went

head light angle - so it doesnt blind people and lights up a reasonable amount of the road - wait until it is dark and shine your headlights up against a garage wall or somthing, should be easy enough to see if they are too high.
GSX-R600 K4
ZXR400 H2
Commuter: Gilera Runner 180SP
Contributing writer to:http://jocke.selincite.com
ZXR400 H2
Commuter: Gilera Runner 180SP
Contributing writer to:http://jocke.selincite.com