K&N with no snorkal and aftermarket Can

[MillaMeter]

Hi,

Straight to the point here, basically I have a K&N air filter fitted with no snorkal and a after market no baffle s/steel end can. What I need to know is what jet sizes to use and what needle settings?

Thanks

Richard

[rover220]

i have a k and n with the snorkel removed and have 105 main jets.

[MillaMeter]

i have a k and n with the snorkel removed and have 105 main jets.

Thx for reply,

was that from a Dynojet kit by any chance?

Thx

Rich

[zimm]

#105 keihin jets , equivalent dynojet ones would be #100/#102 for that setup

[rover220]

#105 keihin jets , equivalent dynojet ones would be #100/#102 for that setup

cheers dude

[zimm]

you've got dynojet needles too Mike, stock needles may require different jets.

[thermal]

why is it when using a KnN, you need to remove the snorkel?

[zimm]

general consensus is that the KnN blocks the snorkel partly and runs richer than stock with it fitted.

sounds better without it too.

[thermal]

in which case is it worth removing the snorkel even when using the standard air filter? what is the purpose of the snorkel anyway?

[zimm]

the OE filter is different to the KnN, it doesnt block the end of the snorkel.

you can remove it, but you'll need to re-jet, and maybe play with needles.

its to smooth the airflow to help prevent flatspots, and to quieten the induction noise.

[thermal]

i dont want it to be quiet. if i put a knn on, will it still need re-jetting?